Again to avoid cross contamination between products it is often best to use a plastic trash bag as a liner for the mop bucket.
Strip new floor before waxing.
When floors are stripped or it s a new floor we need to neutralize the floor then apply a floor sealer.
Use a clean cotton blend mop and neutral cleaner to mop the floor.
This is at least two extra steps and is more labor intensive not to mention the extra products needed for a strip and wax job.
Wash the surface well and apply finish to floor much easier and much quicker job than stripping.
When floors are scrubbed we do not need to neutralize and seal the floor.
The mop matters.
After the floor is completely dry fill the mop bucket with wax sealer.
Prep before finish.
The post wax wait time is the same for existing vct as well.
Waxing is too labor intensive.
If your floor is new and relatively clean without visible dirt imperfections you could first try using a red pad and a neutral floor cleaner.
If you don t clean the tile well before applying wax you could encounter several issues including surface tension issues like the wax separating in circles adhesion or lay issues and a slue of unforeseables.
Additionally you ll be able to see the discoloration in the floor because the dirt will be trapped between the wax layers.
Thoroughly rinse neutralize and dry your floor before applying the finish.
If any wax if found on the knife you may need to re strip these areas.
Some types of floor especially hardwood may be damaged by certain types of floor finish stripper.
For the best results have the vct stripped and waxed prior to moving furniture or people into the space ideally allowing a full 24 hours of cure time before it is walked on.
Applying wax to flooring.
Failure to do this will result in a poor bond between the wax and the floor.
Not stripping wax before putting down a new coat.
Step 1 purchase a floor finish stripper that is appropriate for your floor.
For best results use a floor finish stripper that is the same brand as the floor wax you last used.
Once new vct is installed it must be properly stripped and waxed with at least two coats of wax applied.
Some floor finish strippers are step 2 rent an electric floor scrubber and a wet dry vacuum recommended.
Anyone who ever had to strip and wax their floor knows it can take a lot of time and effort especially if you ve got multiple floors or large areas to cover.
Proper application takes time and skipping steps can send you back to square one again.
Use a clean synthetic fiber mop to apply the finish.
Check the label before buying to make sure it is safe to use on your type of floor.
If you don t strip the old wax off before putting a new layer down you re encasing dirt grime and debris between the old and new layer of wax.
This will also neutralize the alkalinity of the floor caused by the stripper chemical.
Unlike applying the stripper be sure not to flood the floor area.
The general process involves using a floor machine to strip away the existing wax.
From there apply the wax to the flooring.
